Stanhay’s belt metering units are lightweight, simple and extremely versatile and can be used with a wide range of both raw and coated seeds.

From a pedestrian operated unit to large tractor mounted machines our drills can suit both the small and large grower


 The metering unit accurately places seed in the ground with the minimum of damage as every moving part is rubber covered. Seeds in the hopper fall past the choke (A) which regulates the quantity of seed in the chamber. The seed belt (B) is rotated clockwise by the drive wheel (C) while the repeller wheel (D) rotates anticlockwise to remove excess seed away from the holes in the belt only allowing the required amount to drop through at the end of the spring base (E). The seed drop into the bottom of the furrow is only 25mm minimising bounce or roll of the seeds.

By fitting the right combination of coulter, choke, base and seed belt punched with the correct size and number of holes in single, double or triple lines you can plant a wide variety of seed types at any spacing or pattern. Swapping these items to switch between seed types can all be done without the need for tools. The metering unit can be fitted into three different chassis types to suit a range of grower requirements.

Screenshot 2017-12-12 16.10.45.png
Screenshot 2017-12-12 16.46.21.png
 

The Belt Drills

 
Screenshot 2017-12-12 16.18.15.png

820 Handpush

The highly versatile 820 Handpush is designed for planting small areas and quantities of seed at a time.

Screenshot 2017-12-12 16.18.15.png

820 Handpush

The highly versatile 820 Handpush is designed for planting small areas and quantities of seed at a time.
 

Screenshot 2017-12-12 16.18.15.png

820 Handpush

The highly versatile 820 Handpush is designed for planting small areas and quantities of seed at a time.
 

 

Compare Our Drills

Guide.jpg

Comparison Table

For a full comparison table simply download our .pdf below